Page 2 of 2

Re: finding plateau voltage

Posted: 21 Jun 2018, 06:35
by keuleeule
Cath - Anode 4,47MOhm
Remember V(real) = V(display) * (a)/(a+b)
Where a = divider resistance and b = load resistor resistance
V(real) = 730V * 4,47M/4,47M + 1M
= 596V
_______________________________________________

Re: finding plateau voltage

Posted: 21 Jun 2018, 07:58
by keuleeule
20180620_235258_kl.jpg
Ok, if there is nothing on the output, only Oscilloscope, the 200mV are gone.
I tried to copy long therm, 5s/div
only 20mV peaks... have a look to the picture...

Re: finding plateau voltage

Posted: 21 Jun 2018, 08:42
by Steven Sesselmann
Kolja,

With that divider (5.2M Ohm) the voltage on the GS-PRO display will read about 20% higher than actual voltage, so when you are running at 1350V the real voltage is only around 1100V.

This reason and also the limited current available from the USB bust, is why I recommend a 12 M Ohm divider.

PS: Can you also confirm that your sound card is not inverting the pulses. It is a common mistake to set the pulse height threshold with the wrong sign, i.e. if the pulse is negative your threshold in PRA must be set to a negative number (-0.3) else it will be looking for your pulse above the baseline instead of below.


Steven

Re: finding plateau voltage

Posted: 21 Jun 2018, 10:36
by Steven Sesselmann
Kolja,

If you like we can hook up for a quick Skype or Facetime call, then we may be able to narrow down the problem quickly.

Steven

Re: finding plateau voltage

Posted: 23 Jun 2018, 01:42
by keuleeule
yes yes yes, Steven showed me how to adjust the pre-amp volume and showed me that my soundcard SoundBlaster X-Fi HD USB does a bad job...
Now I get real spectra, still struggleing with calibration, but my day just starts, so I can run several tests now.

My first impression is worth it, as 15years ago I collected smoke detector sources containing Ra, each one had two sources in and by mistake I found 5 metall plates in my container - so one too much.
Which one is Am instead of Ra? ok, that one would be quite easy, but now I was able to find exactly the right one. Perfect.

I will share the Spectra when Im done...

Kolja