I just broke down a purchased the GS-USB-PRO with a BNC to SHV cable. I am looking forward to experimenting with this driver, though I don't see any videos of this in action just yet.
I am curious if using the line out and the RH electronics count rate meter would be compatible, using the line out to trigger event counting on such a device?
GS-USB-PRO Driver question
-
Sesselmann
- Posts: 1392
- Joined: 27 Apr 2015, 11:40
Re: GS-USB-PRO Driver question
Conor,
I can't comment on the RH counter as I haven't used one, but the analogue output on the GS-USB-PRO is essentially the same as the original GS-1100A and GS-1100-PRO and allows you to connect the analogue signal to a sound card. The same connector also doubles as a right channel input and a TRRS output (my special unconventional wiring).
Steven
I can't comment on the RH counter as I haven't used one, but the analogue output on the GS-USB-PRO is essentially the same as the original GS-1100A and GS-1100-PRO and allows you to connect the analogue signal to a sound card. The same connector also doubles as a right channel input and a TRRS output (my special unconventional wiring).
Steven
-
Conor Whyte
- Posts: 126
- Joined: 28 Apr 2019, 15:06
Re: GS-USB-PRO Driver question
Ok, just checked on the counter circuit..
I'd have to convert the analog pulse from the GS-USB-PRO into a 3.3V TTL logic pulse for the ratemeter to see any counts, probably needing a discriminator as well.
Another experiment to try.
I'd have to convert the analog pulse from the GS-USB-PRO into a 3.3V TTL logic pulse for the ratemeter to see any counts, probably needing a discriminator as well.
Another experiment to try.
